ABV calculator, with fruit and sugar added along the way
Enter your original and final gravity for the strength, how much of the sugar the yeast ate, and roughly how many calories are in a glass. Added fruit or sugar part way through? Add the readings either side of it and they’re counted too.
How it works
Strength comes from the drop in gravity: (OG − FG) × 131.25 gives the ABV as a percentage. It’s the formula most homebrewers use, and it’s accurate to within a few tenths for beers and wines of normal strength.
Fruit or sugar added during fermentation brings more sugar for the yeast, which a simple OG and FG miss. A reading just before the addition and another just after show how much it added: the rise is counted as if it had been in the original gravity.
Attenuation is the share of the sugar the yeast fermented: (OG − FG) ÷ (OG − 1). Calories come from the standard brewing formula, from the alcohol (7kcal a gram) and the sugars left behind (4kcal a gram).
From our brews
Zing, our soured double IPA, started at 1.056. On day 11 it read 1.012, then 4.5kg of mango, pineapple and papaya took it back up to 1.016, and it finished at 1.006. OG and FG alone say 6.6%; counting the fruit, it’s 7.1%.
Pilot Episode went from 1.052 to 1.011: 5.4% ABV, 79% attenuation, and about 240kcal in a 500ml bottle.
Questions
- Why does my ABV look low after adding fruit?
- Because the fruit’s sugar never shows in your original gravity. Take a reading just before you add it and another once it’s stirred in, and put both into the calculator.
- How accurate is the 131.25 formula?
- For most beers it’s within about 0.2%. Very strong beers and wines can read a little low; the figure is an estimate either way, as hydrometers are only as precise as the reading.
- Can I use it for wine or cider?
- Yes. A wine finishing below 1.000 is fine; attenuation will read over 100%, which is normal for a dry wine, as alcohol is lighter than water.
- What’s the difference between original and final gravity?
- Original gravity is your reading before the yeast goes in: how much sugar is in the wort. Final gravity is the reading once fermentation has finished. Yeast turns sugar into alcohol and CO₂, so the gravity falls, and how far it falls tells you how strong the beer is.
- How do I know fermentation has finished?
- Take a gravity reading, then another two or three days later. If they match, it’s done. Bubbles in the airlock slowing down aren’t enough on their own: fermentation can stall and start again.
- Do I need to correct my hydrometer for temperature?
- Yes, if your sample is much warmer or cooler than the temperature your hydrometer is calibrated to (usually 20°C, printed on it or its packet). Hot wort reads low, so either cool the sample first or put it through our hydrometer temperature correction calculator before you use the reading here.
- What does attenuation mean?
- How much of the sugar the yeast ate, as a percentage. Most ale yeasts land somewhere between 65% and 85%; a stuck fermentation shows up as attenuation that’s much lower than the yeast should manage.
- How are the calories worked out?
- From the same two readings: the alcohol the yeast made and the sugar it left behind both carry calories. It’s an estimate, as the formula assumes a typical beer, but it’s a fair guide to what’s in a glass.
More tools
Hydrometer correction
Correct a hydrometer reading taken from warm or cold wort or beer to its true gravity, for the temperature your hydrometer is calibrated to.
Open the hydrometer correctionCarbonation calculator
How much priming sugar, or how many carbonation drops, to put in each bottle for the fizz you want: for 330ml, 500ml and 750ml bottles.
Open the carbonation calculatorBottle calculator
How many bottles a homebrew batch will fill, in 330ml, 500ml, 750ml or any size, after the sediment, with spares to sanitise in case.
Open the bottle calculatorWater calculator
Mash and sparge water for an all-grain brew day, from your grain bill, batch size and kettle’s boil-off, with a warning before the kettle overflows.
Open the water calculatorIBU calculator
Estimate how bitter a homebrew will be, in IBU, from the hops you boil, the alpha acid on each packet and how long each one boils.
Open the IBU calculatorRecipe scaler
Scale a homebrew recipe or kit to the batch size you want: grain, hops, sugar and fruit, from a big kit down to a demijohn or up to a bigger brew.
Open the recipe scalerDilution calculator
How much water to add to bring your wort or beer down to a gravity, or what the gravity will be once you top it up with water.
Open the dilution calculator